www.gt4dc.co.uk http://www.gt4dc.co.uk/forum/ |
|
Race Spec diff subframe bushes http://www.gt4dc.co.uk/forum/viewtopic.php?f=1&t=7230 |
Page 2 of 2 |
Author: | TrackToyFour [ Fri Dec 05, 2014 9:26 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
Thanks for posting the measurements Lou. I think I would have gone slightly bigger with the OD with the plan of freezing the bush, warming the diff carrier and then using a ten tonne press to install. Might seem like more of a hassle but at least you know the bush isn't going to move. |
Author: | mixer72 [ Fri Dec 05, 2014 11:12 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
im going to make 1 at 50mm and see what its like to fit and go from there |
Author: | mixer72 [ Tue Dec 16, 2014 8:37 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
an other kit off out to Nairobi, in Kenya the bushes are now a little bigger so a tighter fit |
Author: | DeeCee [ Wed Dec 17, 2014 8:36 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
Could it be the camfer on the edge of the bush not allowing it to sit properly inside the bushing housing? |
Author: | mixer72 [ Wed Dec 17, 2014 8:54 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
they sit on the these bushing housing nice just for some reason the 1 I made were just that little bit to lose, but the set I have just sent out fit nice and tight, they needed a piece of wood on the back and a hammer to make them fit, so this is the size ill be making them fro now on |
Author: | mixer72 [ Thu Jan 08, 2015 3:33 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
another diff mount off out |
Author: | mixer72 [ Sun Feb 01, 2015 5:26 pm ] |
Post subject: | Re: Race Spec diff subframe bushes |
Busy turning more Race spec parts today, GT4 Diff Hanger Bushes |
Page 2 of 2 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |