www.gt4dc.co.uk http://www.gt4dc.co.uk/forum/ |
|
rev 3 block/head dimensions http://www.gt4dc.co.uk/forum/viewtopic.php?f=13&t=5394 |
Page 1 of 1 |
Author: | niblettr [ Tue Feb 07, 2012 2:57 pm ] |
Post subject: | rev 3 block/head dimensions |
Looking to fabricate a torque plate (sorry about the cross post from the maintanance section) and I need the dimensions of the head bolt holes bores etc to start drilling out my plate Not the end of the world if I can't get this info as I can measure up a head gasket to roughly the same info (just would be nice for some accurate info.) cheers |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |